This is a working overview of lyophilized powder, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2025-12-31. Anything still debated is marked as such rather than presented as settled.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
Laboratory descriptions of the material are consistent across suppliers. It appears as a white to off-white lyophilized powder that dissolves readily in water and in polar organic solvents such as dimethyl sulfoxide. Aqueous solutions are clear and colorless at low concentrations. Because the peptide contains methionine, oxidation at the sulfur atom is a recognized degradation pathway, and handling notes usually call for protected, desiccated storage. Reported purity for research-grade lots is generally above 95 percent as measured by reversed-phase high-performance liquid chromatography.
The compound is registered in Russia as a pharmaceutical product, most commonly formulated as a nasal solution, and has been used in that setting since the 1990s. Outside that jurisdiction it is generally handled as a research chemical rather than an approved medicine. Regulatory status therefore differs sharply between countries, and material sold internationally may not correspond to the Russian pharmaceutical formulation. Documentation with commercial samples is typically limited to a certificate of analysis covering purity and identity, not clinical status or local legal classification.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Identity and purity are confirmed with reversed-phase high-performance liquid chromatography, typically monitored at 214 nanometres where the peptide bond absorbs. Mass spectrometry, either electrospray or MALDI-TOF, verifies molecular mass against the theoretical value and detects truncation or adduct formation. Amino acid analysis and peptide mapping provide additional confirmation when required. The most frequently reported impurities are deletion sequences from incomplete coupling, methionine sulfoxide from oxidation, and dimeric species formed through non-covalent aggregation. Impurity profiles depend strongly on the synthesis and purification route chosen by the producer.
Published research has focused mainly on neurological and cognitive endpoints in animal models, with proposed mechanisms involving brain-derived neurotrophic factor and related signalling pathways. A substantial share of the human data originates from a limited number of research groups, and independent replication in other countries remains sparse. Regulatory status reflects that distribution: the peptide is registered as a medicine in Russia and appears in some neighbouring markets, while elsewhere it is handled as a research chemical without approved therapeutic labelling. Questions about dose-response relationships, long-term effects, and comparability across studies are still open.
各国监管态度分化明显。俄罗斯按处方药管理，部分东欧国家留有使用记录；欧盟与美国未批准其作为药物上市，市面流通品通常标注为研究用化学品。身份差异意味着标示含量、纯度与无菌性缺少统一核查。体育领域还牵涉反兴奋剂名录，跨境携带则受目的地药品法规约束。
Semax 是人工设计的七肽，序列为 Met-Glu-His-Phe-Pro-Gly-Pro，骨架取自促肾上腺皮质激素片段 ACTH(4-10)。它于二十世纪八十年代在苏联的分子遗传学研究机构内合成。设计目标是保留该片段与注意力和记忆相关的活性，同时剔除促皮质激素释放等内分泌作用。此后俄罗斯将其登记为药品并进入临床使用。
当时的短肽研究普遍关注能否穿越血脑屏障、在低剂量下产生中枢效应，Semax 属于这一路线。鼻内给药是其主要使用方式，俄语文献报道的适应症涵盖缺血性卒中、短暂性脑缺血发作、认知功能减退以及视神经病变。这些研究大多发表在当地期刊上，样本规模与终点设置同西方试验惯例存在差异，国际同行对其临床证据的强度看法不一。
== Measurement == These different definitions have true physical meaning because different techniques in physical polymer chemistry often measure just one of them. For instance, osmometry measures number average molar mass and small-angle laser light scattering measures mass average molar mass. Mv is obtained from viscosimetry and Mz by sedimentation in an analytical ultra-centrifuge. The quantity a in the expression for the viscosity average molar mass varies from 0.5 to 0.8 and depends on the interaction between solvent and polymer in a dilute solution. In a typical distribution curve, the average values are related to each other as follows:
=== Biological actions === β-TG is a chemoattractant, strongly for fibroblasts and weakly for neutrophils. It is a stimulator of mitogenesis, extracellular matrix synthesis, glucose metabolism, and plasminogen activator synthesis in human fibroblasts. β-TG also affects megakaryocyte maturation, and thus helps in regulating platelet production.
In 1955, a USAF surgeon who advised the US Surgeon General wrote an article on how to make cars safer for those riding in it. Aside from the usual safety features, such as seat belts and padded dashboards, bumper shocks were introduced. In 1956, Ford tried unsuccessfully to interest Americans in purchasing safer cars with their Lifeguard safety package. (Its attempt nevertheless earns Ford Motor Trend's "Car of the Year" award for 1956.) In 1958, the United Nations established the World Forum for Harmonization of Vehicle Regulations, an international standards body advancing auto safety. Many of the most life saving safety innovations, like seat belts and roll cage construction were brought to market under its auspices. That same year, Volvo engineer Nils Bohlin invented and patented the three-point lap and shoulder seat belt, which became standard equipment on all Volvo cars in 1959. Over the next several decades, three-point safety belts were gradually mandated in all vehicles by regulators throughout the industrialised world. In 1959, American Motors Corporation offered the first optional head rests for the front seat. Also in 1959, the Cadillac Cyclone concept by Harley Earl had "a radar-based crash-avoidance system" located on the nose cones of the vehicle that would make audible and visual signals to the driver if there were obstacles in the vehicle's path.
Sources: en.wikipedia.org
Romanowsky discovered that instead of fresh methylene blue, an aged and mouldy solution gave the best result, while eosin should be free of any contamination. He described:For staining [blood sample having malarial infection] the following mixture is used, as discovered by me, which is best when freshly prepared: 2 volumes of a filtered saturated aqueous solution of methylene blue plus 5 volumes of a 1% aqueous eosin solution... In my preparations I always obtain the following picture. Red cells are stained in a pink color. Cytoplasm in eosinophils is saturated-pink, whilst that in the malaria parasite and lymphocytes is light blue. Blood platelets and the nuclei of white cell are dark-violet, whilst the nuclei of malaria parasites are purple-violet. The cytoplasm of leukocytes is pale-violet, with transitional colors between the light blue protoplasm of lymphocytes to violet leukocytes. Within red cells the malaria parasite may be hardly noticeable or may occupy the whole cell. In any event, the violet nucleus, surrounded by a colorless rim, is always clearly distinguishable.Romanowsky gave an elaborate description of the new technique in his thesis submitted in June 1891. The staining method remains the "gold standard" for visualising blood samples, especially for malarial infection, and in immunohistochemical studies.
58. Dermatol Online J. 2018 May 15;24(5):13030/qt2gz9f9jk. A glimpse into the underground market of melanotan. Callaghan Iii DJ(1). Author information: (1)Department of Dermatology, Boston Medical Center, Boston, Massachusetts. danieljcallaghan3@gmail.com. Melanotan-I and melanotan-II are alpha-melanocyte stimulating hormone (a-MSH) analogues that can be purchased illicitly online with relative ease and are injected subcutaneously to stimulate a tan. Little is known about the use of these unregulated substances. An observational survey was posted to an online forum in which participants share their experiences using melanotan-I or melanotan-II. Users were asked to complete this voluntary, anonymous survey, which had questions focusing on motivation and hesitation for and against using melanotan, difficulty in acquiring it, and plans for continuing to use melanotan in the future.
== Characteristics == Collagen is one of the long, fibrous structural proteins whose functions are quite different from those of globular proteins, such as enzymes. Tough bundles of collagen called "collagen fibers" are a major component of the extracellular matrix that supports most tissues and gives cells structure from the outside, but collagen is also found inside certain cells. Collagen has great tensile strength and is the main component of fascia, cartilage, ligaments, tendons, bone, and skin. Along with elastin and soft keratin, it is responsible for skin strength and elasticity, and its degradation leads to wrinkles that accompany aging. In the skin, collagen and elastin have complementary roles within the extracellular matrix. Collagen provides tensile strength and structural support, whereas elastin is a major component of elastic fibers that enables the skin to stretch and return toward its original shape. With intrinsic aging and chronic ultraviolet exposure, both collagen and elastic fiber networks undergo structural and quantitative changes, contributing to reduced skin elasticity, wrinkles, and laxity. Studies of dermal tissue have identified changes in the density and organization of both collagen and elastin as characteristic features of intrinsic aging and photoaging. In the skin, collagen and elastin have complementary roles within the extracellular matrix: collagen provides tensile strength and structural support, whereas elastin is the principal component of elastic fibers that allows skin to stretch and recoil toward its original shape.
In the periodic table, americium is located to the right of plutonium, to the left of curium, and below the lanthanide europium, with which it shares many physical and chemical properties. Americium is a highly radioactive element. When freshly prepared, it has a silvery-white metallic lustre, but then slowly tarnishes in air. With a density of 12 g/cm3, americium is less dense than both curium (13.52 g/cm3) and plutonium (19.8 g/cm3); but has a higher density than europium (5.264 g/cm3)—mostly because of its higher atomic mass. Americium is relatively soft and easily deformable and has a significantly lower bulk modulus than the actinides before it: Th, Pa, U, Np and Pu. Its melting point of 1173 °C is significantly higher than that of plutonium (639 °C) and europium (826 °C), but lower than for curium (1340 °C). At ambient conditions, americium is present in its most stable α form which has a hexagonal crystal symmetry, and a space group P63/mmc with cell parameters a = 346.8 pm and c = 1124 pm, and four atoms per unit cell. The crystal consists of a double-hexagonal close packing with the layer sequence ABAC and so is isotypic with α-lanthanum and several actinides such as α-curium. The crystal structure of americium changes with pressure and temperature. When compressed at room temperature to 5 GPa, α-Am transforms to the β modification, which has a face-centered cubic (fcc) symmetry, space group Fm3m and lattice constant a = 489 pm. This fcc structure is equivalent to the closest packing with the sequence ABC.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
It is registered as a pharmaceutical product in Russia, where it is typically supplied as a nasal solution. In most other countries it is not an approved drug and is traded as a research chemical instead. Approval status depends entirely on the jurisdiction involved.